hestan KRB Series Installation Manual page 28

OVERLAY PANELS
MOUNTING OVERLAY PANELS TO DOOR
EN
26
©2019 Hestan Commercial Corporation
(CONT.)
6
7
8
9
10
11
Hook the panel to the hanger bolts starting
from the top aligning brackets (6).
After the panel is hooked on all hanger
bolts, install the two vertical adjustment
screws.
See (9) below.
At this point, alignment between the
panel and adjacent cabinets can be
adjusted using the alignment brackets and
brackets (7) and (8).
Vertical alignment: tighten or loosen the screws
in the brackets to raise or lower the panel. (9)
Depth alignment: working from the inside of
the door, after lifting up the magnetic seal,
adjust the panel position so it is closer to or
further away from the door using (10) and then
fix the panel in position using (11)