Overlay Panels - hestan KRB Series Installation Manual

OVERLAY PANELS

DOOR AND DRAWER OVERLAY PANEL PREPARATION
Decorative panels:
The dimensions of the panels are indicated in the table
and drawings on following pages.
To align panels with other kitchen structures, sizes
can be adjusted if the door panel needs to be higher
than the upper edge of the refrigerator door, and/or
the drawer panel needs to lower than the edge of the
drawer.
The panels must be mounted using special braces which
attach to adjustable devices provided on the door and
drawer and with brackets that anchor and adjust the
panel's vertical direction.
Braces, brackets and fixing screws are provided with
the appliance and must be applied to the panel as
indicated.
Layout procedure:
To prepare the panels to be mounted on the appliance,
follow these steps, working on the back of the panel.
Door Panel
1) Trace a line dividing the panel width in half. (1)
2) Starting from the bottom edge of the panel, mark
the positioning of the brackets. (2)
3) Following the corresponding table, mark the
external and then the internal hole. (3)
1
2
3
2019 Hestan Commercial Corporation
EN
15