Version Table 1: New Firmware Version Model Name Firmware Version WRTD-303N v1.2.24 WAPD-235N v2.2.15 Note: Please check the button on the device to find the Model name...
2 Firmware Update Steps Update an operating device CAUTION: The device will reboot as part of the firmware update process. This will temporarily disrupt network and content access for users. Wirelessly connect to the device using its SSID. Launch a browser and go to http://my.admin . Go to Device Management >...
Page 4
Verify that the upgrade was successful by logging on and checking the firmware version on the Dashboard. Figure 3: Check Firmware Version Disconnect the power supply and leave the power ON for at least 2 hours. Note: Device can be operated within this period. Note: If the battery runs out of power within 2 hours, go to step 8 directly.
Update a whole new device Take out the Content Access Point, connect the power supply. Figure 5: connect the power supply Power up the device by pressing and holding the power button for two seconds. Figure 6: Power button Wirelessly connect to the device using its default SSID. The default SSID is Model Name_xxxxxx (Please see Figure 1 to find the Model Name), where “xxxxxx”...
Page 6
Skip or finish the setup wizard. Figure 8: Admin – Setup wizard Go to Device Management > Firmware Update. (See Figure 2.) Select the method of supplying the firmware file. Upload the file from the local computer Use a USB flash drive. For this method, format a USB flash drive (NTFS or FAT32), put the file on it, plug it into the USB port of the device, and refresh the Device Management page.
Page 7
Figure 1: Admin – Device Management 11. Verify that the upgrade was successful by logging on and checking the firmware version on the Dashboard. Figure 3: Check Firmware Version 12. Update process finished. Content Access Point User Guide...