Replacing The Nanocloud Rotary Humidification Wick - Philips AC3829 User Manual

Filter alert chart
Filter alert light
status
A3 displays on the
screen
C7 displays on the
screen
A3 and C7 display
on the screen
alternately
Replace the NanoProtect filter when
flashes on the screen (fig. ‹).
1
Remove the used NanoProtect filter
from the appliance (fig. Œ).
Note
• Do not touch the pleated filter
surface, or smell the filter as it has
collected pollutants from the air.
• Wash your hands after disposing of
the used filters.
2
Remove all packaging material of
the new NanoProtect filter (fig. f).
3
Place the new NanoProtect filter
into the appliance (fig. g).
4
Touch and hold
reset the NanoProtect filter lifetime
counter .
EN
16
Follow this
Replace
NanoProtect
filter HEPA Series
3 (FY2422)
Replace the
NanoProtect
filter Active
Carbon
( FY2420 )
Replace both
filters
for 3 seconds to
Replacing the
NanoCloud rotary
humidification wick
Filter alert light
status
F1 is displayed
and the filter
replacement light
flashes on the
screen. (fig. )
1
Take the wick wheel off the wick
support (fig. †).
2
Grip the shaft screw on the
other side of the wheel, rotate it
anticlockwise to release the wick
from the wheel (fig. Ž).
3
Unfasten the locks on the edge
of the wheel successively to
disassemble the wick wheel
(fig. ).
4
Take the used NanoCloud rotary
humidification wick out (fig. ).
5
Remove all packaging material
of the new NanoCloud rotary
humidification wick (fig. ').
6
Place the new NanoCloud rotary
humidification wick in the wick
wheel, and then fasten the locks on
the wick wheel (fig. ').
7
Place the wick wheel on the wick
support (fig. m).
Follow this
Replace the
NanoCloud
rotary
humidification
wick