Table of Contents
Advertisement
Quick Links
UNO Cordless Series
Following descriptions maybe different from the real
device. Please keep the real device as the criterion. The
telephone is subject to change without notice. In order
to fully use this device please read this manual carefully.
Bring Innovation to The Elegant Life
_______________________________________________________________________
_BITTEL
Page 1 of 15
BITTEL
User Manual
Cover Models
UNO 67 68 CORDLESS
Advertisement
Table of Contents
Related Manuals for Bittel UNO Cordless Series
Summary of Contents for Bittel UNO Cordless Series
- Page 1 BITTEL User Manual Cover Models UNO Cordless Series Following descriptions maybe different from the real device. Please keep the real device as the criterion. The telephone is subject to change without notice. In order to fully use this device please read this manual carefully.
-
Page 2: Main Features
Thank you for purchasing Bittel product. About Battery: 1. If the battery hasn’t been used for over 5 months after first charging or stored, it needs charge last 8 hours for normal use. 2. The new battery must pass 3-4 times charging and using will reach the peak performance. -
Page 3: Installation
● Both the base unit and handset ringer, volume five-steps adjustable. ● 10 speed dial memory keys to store phone numbers to provide good services for the guests, cordless handset can dial numbers by the speed dial memory keys. ● Data port ●... - Page 4 Screws _______________________________________________________________________ _BITTEL Page 4 of 15 UNO 67 68 CORDLESS...
- Page 5 2. Insert the faceplate to the Faceplate holder Pape Holder Port for holder 3. Install Power and Telephone cord First please connect the T-Cable’s power jack (Marked 1 in the below figure) with the power adaptor. Then please connect the T-Cable’s RJ11 (4 pin. Marked 2 in the below figure) with the telephone line jack in the room.
-
Page 6: Location And Control
4. Acoustics control and connection for signal wire (UNO Media only) Insert the signal ribbon cable which from the bottom side of upper case into the jack labeled “AUDIO CONNECT”, pay more attention to the plug and socket direction and make sure the connection is correct and firm. 5. - Page 7 FLASH MUTE REDIAL SPKR HOLD MUTE FLASH REDIAL/PG LOW BATT VOL - VOL + SPKR CHARGE IN USE TIME SET TUNING 23 22 _______________________________________________________________________ _BITTEL Page 7 of 15 UNO 67 68 CORDLESS...
- Page 8 Corded handset 2(14) Display window---Display the Time, Alarm, Sound and Caller ID. 3(15) Infrared receiving region---Receiving the infrared remote control signal for adjusting time（UNO Media only） 4(16) Paper faceplate---For printing hotel logo and user guide. 5(17) iPod Dock 6（18）Memory keys and Message Waiting Light ---Support one-touch memory 7（19）Digit keys of Base --- Digital key for dialing numbers of base.
- Page 9 HOW TO USE How to use the phone 1. Off-hook 1) For One-line phone, pick up the handset, or press SPKR of the Base or the handset, or press ON key of handset. 2) For two-line model, pick up the handset or press SPKR key or the relevant LINE button of the base or handset.
- Page 10 1). When Base is in use, press VOL key to adjust the receiving volume level of speaker, total five levels. 2). When Handset is in use, press VOL or VOL+/- to adjust the receiving volume of Handset, total five levels. Note: Press HOLD+#+HOLD+VOL+/VOL- to recover the default volume level.
- Page 11 released; when the base is in use, directly press the ON or SPKR button of the handset ( for one-line) or press the relevant held LINE button (for two- line), the communication will be changed to handset. Then please SPKR (for one-line) or relevant LINE (for two-line) to end the communication through the base.
- Page 12 3). Setting the Redial to disappear: Press HOLD+* + HOLD+REDIAL/PG 4). Setting the Redial NOT to disappear: Press HOLD+#+ HOLD+REDIAL/PG 5). Base calls handset: on-hook, press the REDIAL of the base, the handset will ring twice. 10. Adjust ringer volume In On-hook status, press VOL+/VOL- to adjust the ringer volume.
- Page 13 12. MWL Message Waiting Light When there is new message, the MWL will flash, press SPKR or pick up handset and press MWL key can retrieve the message 13. Register and delete the Handset 1） For the model without corded handset First please connect the outside power and correctly install the battery into the handset, then correctly put the handset into the base.
-
Page 14: Fcc Approval
THIS LIMITED WARRANTY GIVES THE BUYER SPECIFIC LEGAL RIGHTS. THE BUYER MAY ALSO HAVE OTHER RIGHTS WHICH VARYFROM JURISDICTION TO JURISDICTION. This warranty is only valid for merchandise purchased directly from Bittel or dealers or distributors Bittel Co. authorized . FCC WARNING This device complies with part 15 of the FCC Rules. - Page 15 (86) 633-2212119/2212113/2212103/2212125 Internet: www.bittelgroup.com www.hotelphone.com Email: info@btitelgroup.com Address: Shandong Bittel Electronics Co., Ltd. No. 1 Rizhao North Road, Rizhao, Shandong, 276800, China Copyright © 2012 Bittel Inc. All rights reserved. V4 _______________________________________________________________________ _BITTEL Page 15 of 15 UNO 67 68 CORDLESS...
Need help?
Do you have a question about the UNO Cordless Series and is the answer not in the manual?
Questions and answers