Porter-Cable PCSRW4800 Instruction Manual page 13

Fig. Y
29
Fig. BB
PART 2: PEGBOARD TOOL HANGERS INSTALLATION (FIG. CC)
NOTICE
These pegboard tool hangers (31) should not carry excessive weight. If the hangers deform in any
fashion, they should not be used any further.
1. Each tool hanger (31) will have at least one 1/4" peg hook that will be used to locate it on the
peg board. Plan out desired tool hanger (31) locations based on the tools or items that will be
stored on them.
2. Slip the peg hook or peg hooks onto the pegboard (24) and let it hang down. If the tool hanger
(31) is seated properly then it should sit flat against the pegboard (24) and not fall.
3. Locate the hole or two holes on the tool hanger (31). These holes should line up with the
pegboard holes. A locking pin (10) is used for each hole to fully secure the tool hanger (31)
to the pegboard (24). (Fig. CC)
Fig. CC
24 31
Fig. Z
10
30
28
29
16 10
30
24
30
24
28
8
4
19
25
25
10
13
Fig. AA
30
29
16