Electrolux ICON Use And Care Manual page 7

Refrigerated drawers
Hide thumbs Also See for ICON:
Table of Contents

Advertisement

Available languages

Available languages

CAUTION
Any finished flooring should be
protected with appropriate material to
avoid damage when moving the unit.
Floor Mount Installation
The anti-tip bracket is to be located on the
floor in the left or right rear corner of the
Refrigerated Drawers.
Step by step instructions for locating
the position of the bracket:
1 Decide where you want to place the
Refrigerated Drawers. Slide them into
place, being careful not to damage
the floor, leaving 1" (2.5cm) of
clearance from the rear wall to allow
room for the anti-tip bracket.
2 Raise the rear leveling legs
approximately ¼" (6mm) to allow
engagement with the anti-tip bracket.
Level the unit by adjusting all the leveling
legs as required. Turning the leveling leg
21 1/2"
(54.6cm)
Rear Leveling leg
Screw
"V" notches
in bracket
Installation
counterclockwise will raise the unit and
clockwise will lower the unit.
3 Make sure the Refrigerated Drawers
are in the desired location, then mark
on the floor the rear and side corner of
the cabinet where the anti-tip bracket
will be installed. If the installation does
not allow marking the rear corner of the
cabinet, then make temporary lines on
the floor marking the front corner of the
cabinet, excluding the drawer. Slide the
Refrigerated Drawers out of the way.
From the temporary line extend the
sidewall line back 21½" (54.6cm).
4 Align the anti-tip bracket to the marks
on the floor so the side of the bracket
lines up with the side of the cabinet
mark, and the "V" notches on the anti-
tip bracket line up with the end of the
21½" (54.6cm) line (Rear of cabinet line).
5 Fasten the anti-tip bracket to the floor
using the supplied screw.
6 Slide the cabinet back into position,
making sure the rear cabinet leveling
leg slides under the anti-tip bracket
engaging the slot.
Anti-Tip
Leveling Leg
Bracket
Bottom View
21
"
1 2
of Refrigerated
(54.6cm)
Drawer Unit
WARNING
TIP OVER HAZARD: One of the
rear cabinet leveling legs must be
engaged under an anti-tip bracket.
7
Front of
cabinet
"V" notches
in bracket

Advertisement

Table of Contents
loading

Table of Contents