Table of Contents
Advertisement
Table 6: DTV742 PID Group (Pidset) Addresses
Config Out
Each Config Out page (Figure 3.5 Config Out 1 Page on page 29) is associ-
(1, 2, 3, & 4)
ated with the ASI output of the same number (Config Out 1 for ASI 1, for
Page
example). Instructions given for Config Out 1 apply to the other three Config
Out pages as well.
As with the Config In page, the left side of the screen lists all input programs
for reference. The right side of the screen is the location for selecting programs
to be placed in the multilplexed output.
The first two columns show the RF input and program number for each Pidset
(PID group) as set up on the Config In page. The remaining columns are used
to configure the output.
The Enabled check box is used to select the programs to be used in the output.
In the screen shown below, RF Input 2, Program 3 and RF Input 2, Program 2
have been selected to be included in the output for ASI Output 1.
800057-01 Rev. B
PID Group
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
PID Addresses
0x110 to 0x11f
0x120 to 0x12f
0x130 to 0x13f
0x140 to 0x14f
0x150 to 0x15f
0x160 to 0x16f
0x170 to 0x17f
0x180 to 0x18f
0x190 to 0x19f
0x1a0 to 0x1af
0x1b0 to 0x1bf
0x1c0 to 0x1cf
0x1d0 to 0x1df
0x1e0 to 0x1ef
0x1f0 to 0x1ff
0x200 to 0x20f
0x210 to 0x21f
28
DTV 742 User's Manual
wegener.com
Advertisement
Table of Contents
