Reinstall The Imv Assembly - ABB Totalflow G5 Series Application Manual

3.6.2

Reinstall the IMV Assembly

Replacing the complete IMV assembly is necessary and applicable in two
component replacement procedures:
— Transducer assembly replacement (either differential or linear assemblies)
— IMV assembly replacement (complete)
To install the complete IMV assembly, perform the following steps:
1. Place the clean weather sealing gasket over the upper body of the IMV
assembly and move the gasket down to the mounting plate just below the
electronic board (Figure 6).
MMI connector
Liquid crystal
display
Lithium battery
Optional I/O
expansion card
Figure 6: µFLO IMV replacement
Battery
tray
Gasket
G5
µFLO IMV
Assembly
(complete)
2105514-001 rev. AB | 15