Searching For Active Channels Within A Group (Active Channel Scan); Adjusting The Monitor Audio Level - Sony UWP-D21 Operating Instructions Manual

3
Press the + button.
The tuner starts to scan through the selected channel
group. When available channels are found, the first
channel number among the available channels starts
flashing on the display.
To display the next available channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the CLR CH
SCAN menu.
4
Press the SET button when the desired channel
number starts flashing.
The search for available channels finishes and the
displayed channel is set.
Once a channel is confirmed, you can select whether
to send the setting via NFC communication.
5
Select YES, and place the N-Marks of the transmitter
and tuner in close proximity.
Information about the channel set on the tuner is sent
to the transmitter, and then the transmit channel is set.
If you do not want to set the transmitter channel,
select NO or perform no action for ten seconds or
longer to not send the setting to the transmitter.
To scan channels automatically
With the tuner power on, press and hold the NFC SYNC
button for at least four seconds to automatically start a
clear channel scan.
Searching for active channels
within a group (Active Channel
Scan)
Procedure for portable diversity tuner (URX-P40)
You can search for channels in use within the specified
channel group. This is useful when using more than one
tuner in combination with a single transmitter.
Before performing this procedure, select the channel
group.
For details, see "Setting the receive channel" (page 21).
1
Use the + or – button to display the ACT CH SCAN
menu.
2
Press and hold the SET button for one second or
longer.
Press and hold until the channel group and "+"
display starts flashing.
3
Press the + button.
The tuner starts to scan for active channels in the
selected channel group. When active channels are
found, the first channel number among the active
channels starts flashing on the display.
To display the next active channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the ACT CH
SCAN menu.
4
Press the SET button when the desired channel
number starts flashing.
The search for active channels finishes and the
displayed channel is set.

Adjusting the monitor audio level

Procedure for portable diversity tuner (URX-P40)
You can set the monitor audio level within the range 1 to
16.
1
Use the + or – button to display the PHONES menu.
The current monitor audio level is displayed.
2
Press and hold the SET button for one second or
longer.
Press and hold until the monitor audio level flashes.
3
Use the + or – button to set the desired monitor audio
level, then press the SET button.
The setting value is stored. The setting is retained
even after the power is turned off.
22