Table of Contents
Advertisement
SONY
SONY
DWX
MULTI-CHANNEL SYSTEM SET UP (Without use of Wireless Studio Software)
ABOUT THE SONY DWX DIGITAL WIRELESS SYSTEM
2.
Preparing Receivers for Frequency Allocation
To avoid any duplicated frequencies or 'Band Mismatch' alerts, it is best to allocate frequencies to all receiver
channels before pairing the Tx units. If the Rx's are already on different frequencies, skip to step 4. Channel
Coordinate allows all Rxs to be allocated individual frequencies at the same time.
Set the band in the receiver menu. The receiver menu is for each separate channel, left and right of the receiver
unit respectively.
RECEIVER MENU> BAND> Set Band
If all receivers are set up in a network then repeat this step for each channel, once all in the same band then go to
STEP 3.
If receivers are not set up within a network or are purposefully in different bands, skip to step 4
3.
Assigning Frequencies using Channel Co-ordinate (same BAND)
On the top receiver (lowest IP address) -
•
UTILITY MENU
o
RF
• CHANNEL COORDINATE
YOU WILL LOSE AUDIO ON THE RECEIVER PERFORMING THE SCAN
To start select Start Scan > Yes
QL
CH COORDINATE > SCAN
TV21-23
START SCAN?
[NO]
RF
K
DWX
Digital Wireless Generation 3
AF/PEAK
(TX WILL SLEEP)
[YES]
BATT
ALERT
Contact Karno Sound for 24hr support:
07747515123 | 07715103222 | 07732398619
Email : contact@karno.com
QL
0
CH COORDINATE > SCAN
00
/2181
-20
SCANNING..
-36
-60
RF
AF/PEAK
470.250MHz
BATT
ALERT
0
-20
-36
-60
6.
Advertisement
Table of Contents
