Finalizing Installation - 3D Printing Systems UP Mini Heater Bed v2 Installation Instructions

8. Carefully slide the UP Mini Bed+
back into the printer across the
top of the spring loaded plastic
pins (circled), again taking care not
to scratch the top of the bed
against the metal rails that
secure the bed.
9. Once the bed holes are aligned
with the plastic block of the build
platform, reinstall the screws.
10. Pressing down gently on the bed
to provide clearance, remove the
Mylar tape on each side of the bed
that was protecting the edges of
the heater element during
installation.