Advertisement
Version 2.4
Beginning with version 2.4d of the Carbide Motion Controller PCB, the controller boards have a purpose-built
port labeled RESERVED, which is intended for a touch probe.
1. Connect the BitSetter:
a. If you only have the BitSetter, you can plug it directly into the port labeled RESERVED as
shown in Figure 12.
b. If you have both the BitSetter and a Touch Probe, use the Probe Adapter PCB as shown in
Figure 13.
Figure 12
NOTE: If your 2.4d/e board is missing the RESERVED label, connect the Touch Probe using the adapter cable and
follow the directions for connecting version 2.1/2.2/2.3 above.
2. After your cable is routed to the Carbide Motion Controller, re-install the controller cover or
enclosure. Make sure not to pinch or accidentally loosen any of the cables.
support@carbide3d.com
Figure 13
docs.carbide3d.com
12/2/19 v1.0
7
Advertisement
