Advertisement
Version 2.1/2.2/2.3 (Using the Legacy Adapter Cable)
Figure 9
1. Connect the female connector (green and white wires) to the probe pins as shown in Figure 9.
2. Connect the red wire (+5V) to the upper-left
pin on the AVR PROGRAMMING label as
shown in Figure 10.
3. Once both wires are plugged in, your board
should look like Figure 11.
4. Connect the Legacy Adapter Cable to the port
labeled TO CARBIDE MOTION on the Probe
Adapter PCB.
5. Connect the BitSetter to the port labeled
TOOL PROBE on the Probe Adapter PCB.
NOTE: If you also have a Carbide 3D probe, plug that into the port labeled TOUCH PROBE on the Probe Adapter
PCB.
support@carbide3d.com
Figure 10
Figure 11
docs.carbide3d.com
12/2/19 v1.0
6
Advertisement
