Philips DVP3368/94 User Manual page 29

[ Sound Mode ]
Select a preset sound effect to enhance
the audio output.
• [ 3D ] – select a virtual surround sound
effect that is produced from the left and
right audio channels.
[ Movie Mode ]
•
for movies.
[ Music Mode ]
•
for music.
[ Speaker Setup ]
When you connect a speaker system, you
can optimize surround output for the
connected speakers.
• [ Front Speaker ]
Option
[ Large ]
[ Small ]
• [ Center Speaker/Rear Speaker ]
Option
[ Large ]
[ Small ]
[ Off ]
• [ Subwoofer ]
Option
[ On ]
[ Off ]
dvp3368_94_en.indd 29 dvp3368_94_en.indd 29
– select a sound effect
– select a sound effect
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
No speaker is
connected.
Description
A subwoofer is
connected.
No subwoofer is
connected.
• [ Speakers Volume ]
level of each speaker to get the ideal
audio balance.
1. OK.
Press
2. Select a speaker, then press
adjust the volume.
3. Press OK to confi rm and exit.
[ Speakers Delay ]
•
for the center, subwoofer and rear
speakers if they are placed closer to the
listening position, so that the sound
output from all speakers reach the
listening position at the same time.
1. OK.
Press
2. Select a speaker, then press
set the delay time.
3. Press OK to confi rm and exit.
Note
•
[ Speaker Setup ] setting is only available if you have
set the [ Analog Output ] setting to [ Multi Channel
].
[ CD Upsampling ]
For better sound quality in stereo mode,
convert the music CD to a higher sampling
rate.
[ Off ]
• – turn off CD-upsampling.
• [ 88.2kHz ] – convert to twice the
original sampling rate.
[ 176.4kHz ]
• – convert to four times
the original sampling rate.
[ Night Mode ]
You can play DVDs with Dolby Digital
mode at a low volume, without disturbing
others. High volume output is decreased
and low volume output is increased to an
audible level.
[ On ]
• – turn on night mode.
• [ Off ] – enjoy surround sound with its
full dynamic range.
– Set the volume
b B to
– Set the delay time
b B to
29
2/19/2009 12:16:21 PM 2/19/2009 12:16:21 PM