Factory Settings; Temperature Regulation - Geco GA03HA-01 User Manual

GA03HA-01 User Manual
6.4.4. Temperature stablization
In order to ensure the effective regulation of room temperature, the GA03HA room panel offers the
following regulation settings:
The chosen regulation setting is indicated with the symbol „V".
Stabilize temperature by CH pump blocade
The temperature is regulate by panel which blocke CH pump when temperature is too low in the boiler or
temperature inside the room is too high.
Standard stabilize temperature by stabilization factor.
Room panel adjust set temperature on the controller which depend of stabilization parameter (1-6) and
actual temperature in room.
If you would like to change the temperature regulation, select one using the keys
the selected type of regulation will be highlighted. Press the button
the screen. If the previous regulation was standard and you would like to select adaptive regulation, the
screen displays the question:
Accept the change using the button
„V" is displayed next to adaptive regulation. If you do not want to accept the change, use the button
to return to the previous setting and return to the previous menu.
The same procedure applies to changing from adaptive regulation to standard regulation.
blokady pompy CO.

6.4.5. Factory settings

To return to factory settings when in user settings, choose the position „factory settings" using the
buttons or
Page 20
. This will change the regulated to adaptive, and the symbol
, and press . The screen will display the question:
Edition I
PPUH „GECO" Sp. z o.o.
or
to display the chosen regulation on
Valid from 2017-07-26
and