Urrea SC907A User Manual And Warranty page 22

2. Carefully guide the saw along the straight
edge for a straight rip cut.
3. Push the saw forward slowly enough that
the blade is not laboring.
EDGE GUIDE
The saw comes with an edge guide. It allows
you to make accurate parallel cuts.
The edge guide attaches to the saw base and is
secured in place with a turn screw.
USING THE EDGE GUIDE
Always use a guide when making long or wide
rip cuts with your saw. You can use either a
straight edge or use the edge guide that was
included with the saw.
WARNING: Always unplug the saw before
making any adjustments. Failure to unplug the
saw could result in accidental starting, which
can cause serious personal injury.
1. Unplug the saw from the power source.
2. Position the edge guide so that the ruler side
of the arm is facing up. Slide the arm of the
edge guide through the mounting slots at the
front of the saw base.
3. Adjust the edge guide to the desired width
of cut.
4. Tighten the edge-guide lock knob.
When using the edge guide, position the face
of the edge guide firmly against the edge of
the workpiece. This will help to make a true
cut without binding the blade. The edge of the
workpiece must be straight for the cut to be
straight. Use caution to prevent the blade from
binding in the cut.
Edge
Guide
22
USING THE LASER GUIDE
Your tool is equipped with a laser guide that
feeds directly from the power supply (no bat-
teries required) that you can activate anytime
during operation, activate with the switch lo-
Straight
cated in the superior part of the housing.
Edge
NOTE: The laser guide does not need to be
adjusted for bevel cuts after it is aligned for
straight 90° cuts.
AVOID DIRECT EYE EXPOSURE. DO NOT stare
into the laser light source. Never aim light at
another person or object other than the work-
piece. Laser light can damage your eyes.
hance the laser light. Tinted glasses will reduce
overall vision for the application and interfere
with the normal operation of the tool.
piece with a reflective surface. Bright shiny re-
flective sheet steel or similar reflective surfaces
are not recommended for laser use. Reflective
surfaces could direct the beam back toward
the operator.
SETTING THE BEVEL ANGLE
making any adjustments. Failure to unplug the
saw could result in accidental starting, which
can cause serious personal injury.
1. Unplug the saw.
2. Loosen bevel ad-
justment knob.
3. Raise the motor-
housing end of the saw
until the desired angle
setting is indicated on
the bevel scale.
4. Tighten the bevel adjustment knob securely.
Laser Activation
Switch
DANGER: LASER RADIATION.
WARNING: DO NOT use tinted glasses to en-
WARNING: Never aim the beam at a work-
WARNING: Always unplug the saw before
Laser Line
Guide
Bevel
Pointer
Bevel
Adjustment
Knob