Removing The Machine From The Pallet; Lubricating The Machine - Toro GreensPro 1260 Greens Roller Operator's Manual

1. Hitch pedal
7. Insert the locking pin
8. Torque the lug nuts on the transport wheels to
108 N∙m (80 ft-lb).
3
Removing the Machine
from the Pallet
No Parts Required
Procedure
1. Remove the wood blocks at the hitch end of the
pallet.
Figure 8
2. Locking pin
(Figure 8).
1. Wood blocks
2. Place some wood boards on the ground at the
end of the pallet.
Note:
The height of the wood boards should be
slightly lower than the pallet. You can use pieces
removed from the sides and/or ends of the crate.
3. Carefully roll the machine off the pallet, onto the
wood boards, and then to the ground.
g024197
Important:
contact the pallet as the machine drops to
the ground.
4. Remove any remaining packaging.
4

Lubricating the Machine

Parts needed for this procedure:
–
Lubricants (not included)
Procedure
Before you operate the machine, lubricate it to ensure
proper operating characteristics; refer to
(page 25). Failure to properly lubricate the machine
will result in premature failure of critical parts.
10
Figure 9
Ensure that the rollers do not
Lubrication
g024330