1. Manuals
  2. Brands
  3. Heater Sports Manuals
  4. Accessories
  5. Sandlot 2-in-1
  6. Instructions manual

Heater Sports Sandlot 2-in-1 Instructions Manual

Hide thumbs

Advertisement

Table of Contents

Instructions
Follow All Instructions Before Assembling Or Using This Product
IMPORTANT
DO NOT RETURN THIS PRODUCT TO THE RETAIL STORE WHERE
PURCHASED. CALL TOLL FREE: (800) 492-9334
WARNING:
Improper use of this product can result is serious injury. Read and follow the instructions
for the proper and safe use of the Sandlot 2-in-1. Always wear a helmet with a guard.
Adult supervision is required. Inspect the Perfect Swing, rubber bands, base, clamps, etc., before
each use for evidence of any damage. Keep the area clear with-in 24 ft. of the device and
around the swinging area of the batter. Always hit the ball toward an open unoccupied area.
Make sure all knobs and clamps are tightly and securely fastened. Never hit toward
another person. Do not use if damaged or broken.
®
95 West 650 South • St. George, Utah 84770 • PH: 800-492-9334 • PH: 435-656-1756 • Fax: 435-688-0741

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sandlot 2-in-1 and is the answer not in the manual?

Questions and answers

Related Manuals for Heater Sports Sandlot 2-in-1

Summary of Contents for Heater Sports Sandlot 2-in-1

  • Page 1 Improper use of this product can result is serious injury. Read and follow the instructions for the proper and safe use of the Sandlot 2-in-1. Always wear a helmet with a guard. Adult supervision is required. Inspect the Perfect Swing, rubber bands, base, clamps, etc., before each use for evidence of any damage.
  • Page 2 Part List Model# SNDLT2IN1 A - Large Metal Washer E - Lock Washer I - Swivle/Handle Clamp B - Center Pole F - Bolt Wrench J - Support Plate C - Rubber Washer (x2) G - Tension Rubber Bands (x10) K - Perfect Swing Batting Stick D - Base Bolt H - Base Insert Tube...

  • Page 3: Assembly Instructions

    Assembly Instructions Figure 1 Figure 2 Slide one of the Part C (Rubber Washers) over the bottom end of Part B (Center Pole). Slide Part J over the pole end next. Position the slight bend in Part J towards the top end of the pole (Part B) as seen in Figure 1.
  • Page 4 Assembly Instructions Cont. Figure 7 Remove the Rubber Cap on the Center Pole (Part B) and Slide the Swivle/ Handle Clamp (Part I) on to the Center Pole & then replace the Rubber Cap. Figure 7. Figure 8 To adjust the height of the Batting Stick loosen the knob on the adjustment collar attached to the center pole.
  • Page 5 Note: Make sure to use two Rubber Bands for the necessary spring back strength. (The Sandlot 2-in-1 comes with ten tension rubber bands, from time to time it may be necessary to replace worn or broken rubber bands. Just follow the instructions on this page to replace them as needed.)
  • Page 6 Assembly Instructions Cont. Figure 12 With the Tension Rubber Bands (Part G) attached, remove both knobs and lock washers from the “U” shaped clamp on Part 1. See Figure 12. With the two knobs and lock washers removed, slide the “U” shaped side of the clamp off of the fixed side of the clamp.
  • Page 7 The Sandlot 2-in-1 can be used on hard surfaces, grass and dirt. Simply remove the Rubber Stoppers in the Base and fill the Sandlot 2-in-1 with water, sand or cement. Water or sand will be sufficient for most children under 12 years of age. Cement may be necessary for older children and adults.

  • Page 8: Instructions For Use

    Sandlot 2-in-1. After repeated use the Rubber Bands may become weak or break. Simply replace the worn bands when needed. Do not use the Sandlot 2-in-1 without the neces- sary Rubber Bands. This may cause undue stress on the Base and Pole.

Table of Contents