Parts Included With Downdraft; Tools Needed For Installation - Kenmore 233.5996 Series Installation Manual

CLEANING
WARNING: Always disconnect electric power supply
before cleaning unit.
Use a mild detergent suitable for painted surfaces. DO NOT USE
ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING POWDERS.
Vacuum blower to clean. Do not immerse blower in water.
Wash the 2 aluminum grease filters in a mild detergent solution or
a dishwasher. Remove them from the air vent by grasping the tab at
the top of each filter.
NOTE
The filters are different sizes. Be sure to replace them as removed
(wider one on the left), with tabs UP.
Aluminum Grease Filters
Screwdriver
(Flat & Phillips)
Drill

PARTS INCLUDED WITH DOWNDRAFT

(Qty. 2)

TOOLS NEEDED FOR INSTALLATION

Pencil
Sabre Keyhole
-or-
Saw Saw
WARNING: Always disconnect electric power supply
before servicing unit.
It may be necessary to remove the downdraft blower system from
the cabinet in order to service components such as the blower motor
or air vent mechanism.
Disconnect power to the cooktop and remove it first. Reverse the steps
under "MOUNT THE UNIT" to remove the downdraft from the cabinet.
(Contains leveling brackets
Tape
Measure
Duct Tape
4
SERVICING
Parts Bag
& mounting hardware.)
1/4"
Nutdriver
Wire
Stripper