Using Ac Power; Switching Power On/Off; General Operation - Philips AZ1018 User Manual

XP AZ 1018/17 14-11-2000 19:17
Batteries contain chemical substances,
so they should be disposed of properly.
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst.Therefore:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.

Using AC Power

1 Check if the power voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local
power supply. If it does not, consult your
dealer or service center.
2 Connect the power cord to the AC MAINS
inlet and the wall outlet.The power supply
is now connected and ready for use.
3 To switch off completely, unplug the power
cord from the wall outlet.
• Unplug the power cord from the wall
outlet to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
Pagina 9

Switching power on/off:

Save energy
Whether you are using mains or battery
supply, to avoid unnecessary energy
consumption always adjust the POWER
slider to TAPE/
cassette keys are released.

General operation

1 To select your sound source adjust the
POWER slider to CD, RADIO or
TAPE/ .
OFF
2 Adjust the sound with the VOLUME and
DBB (Dynamic Bass Boost) controls.
3 To switch off the set, adjust the POWER
slider to TAPE/
the cassette keys are released.
Note:When the set is switched off the tuner
presets will be retained in the set's memory.
Power Supply
and check if the
OFF
position and check
OFF
9