Table of Contents
Advertisement
Analogue Channel settings - Manual Search
Analogue Ch.
Setup
Entry mode
MHz
Entry
167.5 MHz
Preset
P 04
Preset name
RTL4
Decoder
Off
On
TV system
PAL-BG
Nicam
Off
On
Fine t une
STORE
SEARCH
Entry Mode
Entry
Preset
Preset name
Decorder
TV system
NICAM
Fine tuning
dvdr5350H_UK_Eng2.indd 79
dvdr5350H_UK_Eng2.indd 79
System Menu Options
In some cases, not all of the available TV channels may have been found
and stored during basic installation. In this case, you will need to search
for and store the missing or coded TV channels manually.
A
Press SYSTEM on the remote control. Select { Setup } in the menu
and press
repeatedly to select { Analogue Ch. }.
B
Press
repeatedly to select the following settings in the menu and
press
to enter its options.
Select manual search based on channel allocation or frequency entry
{ Channel, S. Channel (Special channel), MHz (frequency) }.
Note: S. Channel refers to specifi ed hyperband channels.
– Use the alphanumeric keypad 0-9 to enter the frequency/channel
number, press OK and the Green button for { STORE }.
OR
– Press the Blue button on the remote control for { SEARCH }, once
you have found the correct frequency/channel, press the Green
button for { STORE }.
Use the alphanumeric keypad 0-9 to enter the preset channel number
for the channel to store (e.g., '01'), press OK and the Green button for
{ STORE }.
Use the alphanumeric keypad 0-9 to enter the preset channel name,
press OK and the Green button for { STORE }.
Maximum four characters for preset channel name.
If the current TV channel is transmitted by coded TV signals that can only
be viewed properly with a decoder which is connected to the
EXT2 AUX-I/O socket, you need to activate the connected decoder.
{ On }
– Select this to allocate the connected decoder to this
TV channel.
{ Off }
– Turns off the decoder feature.
Set the TV system that produces the least distortion of picture and sound.
See pages 92~93 "TV System Guide" for more information.
NICAM is a digital sound transmission system. It can transmit either one
stereo channel or two separate mono channels.
{ On }
– Improves the sound transmission of the TV channel.
{ Off }
– Select this if the reception is poor and the sound is
distorted.
Select this to fi ne-tune the TV channel manually if the reception is poor.
Use
keys to adjust the frequency and press OK to confi rm.
(continued)
79
2005-10-10 11:00:42 AM
2005-10-10 11:00:42 AM
Advertisement
Table of Contents
