Time Setting; How To Use The Stopwatch - Seiko MOMENTUS CC238 User Manual

C) TIME SETTING
* Before setting the time, check that the chronograph measurement is stopped.
VD50, VD51, VD52, VD53, VD57 (calibres with date window):
1) Pull out the crown to the first click.
2) Turn the crown clockwise until the preview day's date appears.
3) Pull out the crown to the second click when the second hand is at the 12 o'clock position. It
will stop on the spot. Set the hands to the desired time of the day (make sure AM/PM is set
correctly) by turning the crown.
* When the crown is at the second click position, do not press any button. Otherwise the
chronograph hands will move.
4) Push the crown back in the normal position in accordance with a time signal.
* Do not set the date between 9:00 P.M. and 1:00 A.M, otherwise the day may not change
properly. If it is necessary to set the date during the time period, firstly change the time to any
time outside it, set the date and then reset the correct time.
VD54, 55, 56, 59 (calibres without date window):
1) Pull out the crown when the second hand is at the 12 o'clock position. The second hand will
stop on the spot.
2) Set the hands to the desired time of the day by turning the crown.
* Do not press any button, otherwise the chronograph hands will move.
3) Push the crown back to the normal position in accordance with a time signal.
D) HOW TO USE THE STOPWATCH
* The measurement time is indicated by the stopwatch hands that move independently of the
center hands (and
24-hour hand where applicable).
* The stopwatch can measure up to 60 minutes