Articulating Arm - EZ-ACCESS ORBIT 4-FT. ARM Assembly & User Manual

2.2

ARTICULATING ARM

2.2.1 Carefully remove the Articulating Arm (FIG. 2.5) from its
shipping box.
Before using any ancillary equipment with the
ORBIT, refer to your ancillary equipment's Owner
Guide for proper use. Never exceed ancillary
equipment's manufacturer recommendations.
DO NOT exceed the ORBIT Rated Load of 440 lbs.
2.2.2 Determine the working height for the Articulating Arm.
The Articulating Arm Hanger (FIG. 2.1 and FIG. 2.6)
features 3 adjustable height positions for the
Articulating Arm, allowing the flexibility to set
vertical clearance as needed.
2.2.3 The Articulating Arm fits inside the Articulating Arm Hanger (FIG. 2.6) and is bolted in place. After
determining the working height of the Articulating Arm, secure the Articulating Arm into 2 of the
pre-drilled mounting holes using the following supplied hardware:
2.2.4 After installing the supplied hardware, torque each nut to 15 ft./lbs.
The next steps explain pitch adjustment for the Articulating Arm. Until pitch is set and level,
the Articulating arm may free swing. It is important to use caution and level the pitch
immediately.
FIG. 2.6
Page | 7
 2 ea. 1/2"-13 X 3.5" Cap Screws
 2 ea. 1/2"-13 Nuts
 4 ea. 1/2" Washers (one each on nut side and bolt side)
FIG. 2.5
EZ-ACCESS® ORBIT™ Patient Transfer Lift