Advertisement
Quick Links
Advertisement
Related Manuals for Kogan KAHUTRCA810A
Summary of Contents for Kogan KAHUTRCA810A
- Page 1 HUNTING TRAIL CAMERA 24MP KAHUTRCA810A...
- Page 3 OVERVIEW 44PCs IR LED Latch LED Indicator Lens Central PIR Sensor Side PIR Sensor...
- Page 4 8AA Batteries Depot Colour Display Screen Setup Buttons Mode Switch USB Port Micro SD Card Slot Stand Knob Port External Power Port IN THE BOX Camera Quick Start Guide Mounting Strap USB Cable...
-
Page 5: Installation
INSTALLATION If Using AA-Alkaline Batteries Pull the gap lightly and open battery compartment. Refer to the battery icons located on the inside of the battery compartment. Insert the batteries according to the positive and negative battery icons. Close the battery compartment tightly to ensure water and dust resistance. Note: Installing any AA battery in the wrong direction may cause the batteries to leak acid or explode, causing camera failure and damage to the battery compartment. - Page 6 If Using 6V DC Power Source Remove the rubber port cap at the bottom of the camera. Plug a universal 6V DC cord into the bottom port. Run the cord to the side of the camera where there is a hook provided behind the hinge of the camera door.
- Page 7 Memory Card Installation Insert the Micro SD card with the contacts facing away. The Micro SD card should slide in freely with little resistance. Continue pressing the card inward until you hear a click. This means the Micro SD card is locked in place and ready for use. To remove Micro SD card, press the card inwards to release.
-
Page 8: Operation
OPERATION Quick start Slide the mode switch from OFF to TEST position to activate the camera and view the user setup screen. There is a control panel with 8 keys when you open the camera. Operating Buttons MENU Open the Settings menu using the MENU button. REPLAY Press this button to start the replay mode. - Page 9 Auto Recording Mode After entering settings, slide the power switch to ON to enter auto recording mode. The motion indicator will flash red for about 5 seconds, after which the camera will start working. It will automatically take pictures or record videos when a person or animal enters into the area of the PIR sensor.
- Page 10 Camera Menu Settings Camera Sub menu Description Resolution 24MP, 20MP, 16MP Photo size Sequence 1/3/6/9 Number of photos taken sequentially Auto,100, 200, 400 Camera exposure level Delay 1/5/10/30 sec/min Delay between shots Camera ID 0-0-0 Camera ID 0-0-0 Video Menu Settings Video Sub menu Description...
- Page 11 Setup Menu Settings Setup Sub menu Description Mode Camera, video, camera Image, video, image + video, image taken and video, interval at set interval Language English, French, German Camera menu language Time-lapse 5/30/60 Min Taking picture or video for every 5/30/60 interval minutes constantly TV Mode...
-
Page 12: Specifications
SPECIFICATIONS Power 4 or 8 x AA alkaline/lithium batteries external DC6V~12V (3.5 x 1.3mm jack) Connectivity AV out (video cable not included) Water resistance IP65 Photo recording Photo resolution 24MP File format Time lapse mode 5min/30min/60min Multi-shot mode Up to 9 photos per detection Stamp (photos and video) Date, time, temperature (˚C/˚F) and moon phase Capture mode... -
Page 13: Troubleshooting
TROUBLESHOOTING Camera doesn’t capture subject of interest Check the PIR sensitivity for warm environmental conditions. Set the Sensor Level to “Low”; for cold weather use, set the sensor to “High”. Set your camera up in an area where there are no heat resources in the camera’s field of view. - Page 14 This is a Quick Start Guide, and we hope that this has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...