Fashion Sewing Cabinets Of America 898 Manual

Please check all table parts for defects
before discarding any packing material.
List of Hardware:
5x Casters (2 Locking, 3 Non-Locking)
5x 1" Black Caster Bolts
5x Caster Bolt Cover Boots
9x 2" Bolts
9x Cross Nuts
4x Wooden Dowels
9x 5/8" Screws
2x Cam Locks
List of Parts:
Sub assembly (table top)
Shelf
Back Panel
Leaf/Leg support
Left Panel
Center Panel
Right Panel
List of Tools Needed:
#2 Phillips Screwdriver
#3 Flat Screwdriver
Allen Wrench – included
Hammer
1. Begin assembly by placing Sub Assembly unit on a
soft surface with the hinges on the opposite side as
shown in figure 1.
2. Identify and layout the rest of the parts as shown in
figure 2. Before assembly place all the cross nuts
in the numbered holes as indicated in figure 2. For
greater ease in the assembly of this product, the
insertion of the Cross Nuts needs to be done
correctly. Install by aligning the threaded hole in the Cross Nut with the horizontal hole in the
Panel and the slotted end facing out in the hole. Insert two Wood Dowels in the top end of the
Center Panel.
898/898L
Models