Partition Of The Wireless Key Switch - Abus FUBE50061 Installation Instructions And User Manual

Programming values:
Programming value
Note
Under the factory settings, the exit delay for the panel is 10 seconds. If the
exit delay of the panel has been changed, you must also adjust this time
setting for the wireless key switch.
The exit delay time of panels can be viewed in installer mode under the
menu item "Partitions".
When the exit mode of the Secvest is set to "Instant", the reception time of
the wireless key switch should be set to 5 seconds.

8.5. Partition of the wireless key switch

To access this sub-menu, press the programming button (15) five times.
will appear on the display. Hold down the button until
display.
When programming the first partition, the display will show
that the first partition is being set, and after approx. 1 second the current
setting will be displayed (e.g.
pressing the button. When
indicates a partition that has not been selected.
0
1
2
3
4
5
6
). This number can then be changed by
is displayed, a partition has been selected.
Reception time
10 seconds
20 seconds
30 seconds
45 seconds
60 seconds
120 seconds
EN 17
5 seconds
appears on the
to indicate