Adjust Speakers Output - Philips HTS9810/59 User Manual

Adjust speakers output

Ideally the distance between listening position
and all the speakers should be the same. If not,
change the speaker settings based on their
distance from the listening position in order to
obtain the best possible surround sound.
1
Press DISC.
2
Press OPTIONS.
3
Press V to select
menu, then press B.
Audio Setup
Ambisound Setup
HDMI Audio
Speaker Volume
Speaker Delay
Night Mode
Wireless
• You cannot access speaker setup
options if this Home Theatre unit is not
in a complete stop mode. In such case,
press x twice.
To set the speakers volume level
4
Select [ Speakers Volume ] in the menu,
then press B.
Speakers Level Setup
Front Left
Front Right
Center
Subwoofer
Rear Left
Rear Right
24 EN
[ Audio Setup ] in the
0dB
0dB
0dB
0dB
0dB
0dB
5
Press b B to adjust the volume level, then
press OK.
The test tone is emitted from the
speaker which you are adjusting.
• Repeat the above setting for other
speakers until all the speakers output
level sounds equally balance.
To set the output delay time (centre and rear
speakers only)
6
Select [ Speakers Delay ] in the menu,
then press B.
Speakers Delay Setup
Center
Rear Left
Rear Right
7
Press b B to set the delay time, then press
OK.
• Repeat the above setting for other
speakers until the sound output from
different speakers reach the listening
position at the same time.
8
To exit the menu, press OPTIONS.
Tip
•
Set longer delay time if the centre or rear speakers
are closer to the listening position than the front
speakers.
•
1ms setting for every 30cm distance between the
speaker and the listening position.
0ms
0ms
0ms