Advertisement
DOUBLE BOWL UNDERMOUNT VANITY
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures and
plumbing. Signature Hardware accepts no liability for any
damage to the floor, walls, plumbing, vanity cabinet, sink,
counter top, or personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the vanity for damage. If any
damage is found, contact our Customer Relations team
at 1-866-855-2284.
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
Ensure that your bathroom floor is adequately
supported, and the finished floor is level.
Ensure that there is adequate support behind the
bathroom wall before installation.
NEVER LIFT THE VANITY TOP FLAT
NEVER CARRY THE VANITY TOP FLAT
PLANNING
Use the vanity's PDF specification sheet as a reference
when planning your layout. The specification sheet can
be found and downloaded from the product page on
our website.
Because the vanity specification measurements are
approximate and slight variations may occur, we highly
recommend performing any rough-in procedures with
the vanity on site.
TOOLS AND MATERIALS:
Marker*
Tape Measure*
Stud Finder
Level
Wood Shims
Double Bowl Undermount Vantiy Installation Instructions
Drill*
Screwdriver*
Neutral Cure
Silicone Sealant
Damp Cloth
*not included
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Signature Hardware DOUBLE BOWL UNDERMOUNT VANITY
Summary of Contents for Signature Hardware DOUBLE BOWL UNDERMOUNT VANITY
-
Page 1: Before You Begin
fixtures and when planning your layout. The specification sheet can plumbing. Signature Hardware accepts no liability for any be found and downloaded from the product page on damage to the floor, walls, plumbing, vanity cabinet, sink, our website. - Page 2 DOUBLE BOWL UNDERMOUNT VANITY Step 1: Cabinet Installation 1. Determine the location where you would like to install 3. Place the vanity in the installation location. Verify that your vanity. the vanity cabinet is level. If the vanity is not level, adjust the feet (if applicable) or use wooden shims to adjust as necessary.
- Page 3 DOUBLE BOWL UNDERMOUNT VANITY Step 2: Sink Installation 1. Carefully turn the counter top over, resting it on a 3. Use a pencil or marker to draw an outline around the soft, stable surface to prevent damage. sink perimeter. Important: The counter top is very fragile. Take caution when handling, and have someone assist you.
- Page 4 DOUBLE BOWL UNDERMOUNT VANITY 5. Carefully place the sink upside down on the counter 7. Repeat steps 1-6 to attach the second sink to your top, positioning it within your marked outline. Once top. positioned, press firmly into place. 6. At each of the bolt holes in the counter top, attach 8.
- Page 5 DOUBLE BOWL UNDERMOUNT VANITY Step 3: Counter Top Installation 1. Apply a bead of silicone sealant around the top edge 9. Wipe away any excess sealant with a damp cloth, and of the vanity cabinet. allow the sealant to dry. Once the sealant is dry, proceed to Step 3.
- Page 6 DOUBLE BOWL UNDERMOUNT VANITY 5. For stone tops, such as marble and granite, it is 3. If you are installing a side-splash and/or back-splash, recommended that you apply a high-quality sealer to place a generous amount of silicone sealant on the back of it and press it into place against your bathroom protect from staining and discoloration.
Need help?
Do you have a question about the DOUBLE BOWL UNDERMOUNT VANITY and is the answer not in the manual?
Questions and answers