Maintenance
Reinstallation
Oven door
To remove the oven door
1
2
WARNING
•
The door is very heavy. Be careful when removing and lifting the door. Do not
lift the door by the handle.
•
Take care when moving the oven door. Improper handling could result in
physical injury.
•
To prevent electric shock, make sure the oven is turned off before removing
the oven door.
1. Turn off the oven.
2. Fully open the oven door.
3. Pull the hinge locks away from the oven
body and down toward the door frame
into the unlocked position.
4. Close the door to 5 degrees from
vertical. This is the removal position.
5. While holding both sides of the oven
door tightly, lift it up and out until the
hinge arms come clear of the slots at the
bottom of the oven door.
6. Place the door in a safe location.
To reinstall the door
Warming drawer
1. Firmly grasp both sides of the door at
the top.
2. With the door set at the same angle as
the removal position (about 5 degrees
from vertical), slide the hinge arms into
the hinge slots at the bottom of the
door.
3. Open the door fully. If you cannot open
the door fully, the hinge arms are not
properly in the hinge slots.
4. Lock the hinge arms by pushing them
up against the front frame of the oven.
5. Close the door, and make sure it opens
and closes normally.
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Take the drawer by both hands.
Pull down the left clip while lifting up
the right clip to remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
English 49