Advertisement
where inspiration flows
Installation Guide
Thermostatic shower valve with rigid riser and shelf
STRA-149RRK-CP
This instruction booklet covers model:
STRA-149RRK-CP.
Vado
Wedmore Road, Cheddar, Somerset, England BS27 3EB
tel 01934 744466.
fax 01934 744345
aftersales@vado.com
www.vado.com
Keep for future reference
Version 1, 1-3-18
Advertisement
Table of Contents
Related Manuals for VADO STRA-149RRK-CP
Summary of Contents for VADO STRA-149RRK-CP
- Page 1 Installation Guide Thermostatic shower valve with rigid riser and shelf STRA-149RRK-CP This instruction booklet covers model: STRA-149RRK-CP. Vado Wedmore Road, Cheddar, Somerset, England BS27 3EB tel 01934 744466. fax 01934 744345 aftersales@vado.com www.vado.com Keep for future reference...
-
Page 2: General Installation
Important - please read Commissioning Please read these instructions carefully before starting installation and keep for The valve has been factory set under balance pressures and hot water supply at 65°C. future reference. When your specific operating conditions are significantly different from the above, the temperature of the water may vary from the setting. -
Page 3: Contents Of Packaging
Installation - Shower hose Contents of Packaging Shower head Make sure there is a rubber washer in place in the shower head and screw onto Shower head the riser arm. Washer Handset Valve Place one of the rubber washer into the cone end of the hose and screw to the handset. -
Page 4: Installation
Contents of Packaging Installation Replace the riser onto the valve. Slide the riser bracket into the wall bracket. Hex key Secure riser in position using the grub screw on the underside of the bracket. Finally tighten the grub screw to secure the riser to the valve. - Page 5 Installation - riser rail Dimensions Push the riser onto the connection on Riser the top of the valve being careful not to damage the O-rings. 456mm Make sure that the riser is vertical and 250mm mark around the wall bracket with a pencil.
- Page 6 Installation - Quick guide Installation Slide on the olive, screw on and tighten the nut. Before installation flush through the pipe work to ensure removal of debris, turn off the water supply. Olive 150mm Filter/washer Locking nuts Place a rubber filter/washer in each of the locking nuts on the valve and screw onto the connectors.
- Page 7 Installation Installation - Quick guide Note: Make sure that the valve is positioned to allow room for the riser rail to be fitted later (see dimensions on page 6). Prepare the wall with 2 copper pipes at 150mm centres, making sure both pipes are level.
- Page 8 Installation - Quick guide Installation - Quick guide...
Need help?
Do you have a question about the STRA-149RRK-CP and is the answer not in the manual?
Questions and answers