Listen To Radio - Philips HTS6100/75 Quick Start Manual

Listen to radio

1
Press RADIO repeatedly to select 'FM' or
'AM/MW' band.
2
Use the remote control to control the
radio.
Button Action
Select a preset radio station.
Tune the radio frequency
m M
backward/ forward.
Toggle between FM stereo
and FM mono mode.
Press and hold this button to
delete the preset station from
the preset list.
• The preset number for
other radio stations
remain unchanged
Reinstall all the radio stations
1
Press RADIO repeatedly to select 'FM' or
'AM/MW' band.
2
Press and hold PROGRAM until
'STARTING INSTALL' is displayed.
All previously stored radio stations will
be replaced.
Note
•
If no stereo signal is detected or less than 5 stations
are detected during radio installation, 'CHECK
ANTENNA' is displayed.
Search and store radio stations
individually
1
Press RADIO repeatedly to select 'FM' or
'AM/MW' band.
2
Press m M.
The radio frequency indication starts to
change until a radio station is detected.
3
Repeat step 2 until you tune to the radio
station you wish to store.
• To fi netune the radio frequency, press
vV.
4
Press PROGRAM.
• If no action is carried out within 20
seconds after the above step, it exits
the preset mode.
5
Press í ë (or the number buttons) to
select a preset number to store.
6
Press PROGRAM to confi rm.
Change tuning grid
In some countries, the frequency step between
adjacent channels in FM band is 50 kHz or
100 kHz (AM/MW band is 9 kHz or 10 kHz).
Note
•
This feature only applicable for certain region.
•
Change tuning grid erases all preset radio stations.
1
Press RADIO repeatedly to select 'FM' or
'AM/MW' band.
2
Press x.
3
Press and hold u until 'GRID 9' or
'GRID 10' is displayed.
• 'GRID 9' for FM 50 kHz (or AM 9 kHz)
and 'GRID 10' for FM 100 kHz (or AM
10 kHz).
EN 35