Emc Information - Cisco Catalyst IW6300 Series Getting Started

Getting Started and Product Document of Compliance for the Cisco Catalyst IW6300 Heavy Duty Series Access Points

EMC Information

EMC Information
For EMC and safety information, see the
Class A Notice for FCC
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying with FCC
requirements for Class A digital devices. In that event, your right to use the equipment may be limited by FCC regulations,
and you may be required to correct any interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there
is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one
of the following measures:

Reorient or relocate the receiving antenna.

Increase separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from which the receiver is connected.

Consult the dealer or an experienced radio/TV technician.
Caution: The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency
when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could
void the user's authority to operate this device.
Industry Canada
Canadian Compliance Statement
Cisco® Catalyst IW6300 Heavy Duty Series Access Point Model
IW-6300H
Cisco® Catalyst IW6300 Heavy Duty Series Access Point PIDs

IW-6300H-AC-A-K9

IW-6300H-DC-A–K9

IW-6300H-DCW-A-K9
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may
not cause interference. (2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Regulatory Compliance and Safety
15
Information.