Items Required For Installation - GE Lumination LRC Series Installation Manual

Items Required for Installation

1
Installation
1
SHUT OFF POWER to the lighting system.
Remove
2
Remove existing lamp and reflector.
Support
Bracket
Junction box
AC Input Leads:
Green = Ground
White = Neutral
Black = Hot
4
Place the driver enclosure portion of the fixture
assembly in the ceiling next to the rough-in kit so that
the input leads are in close proximity to the existing
junction box to facilitate easy wiring. The driver
enclosure shall be secured to the existing frame.
3
2
5
Ceiling
Driver
enclosure
Quick
connector
1
Fixture Assembly (1 qty.)
2
Reflector (1 qty.)
3
Driver Enclosure Assembly (1 qty.)
4
4
*347V Enclosure Assembly (1 qty.)
5
Support Bracket (1 qty.)
*Required for 347V SKUs
Remove
3
Disconnect wiring. Remove old components, such
as lamp sockets, ballasts, etc. while retaining
existing rough-in kit components.
Junction
box
AC line
wires
5
Connect flex cable end with input leads to existing
junction box. Connect the black, white and green
wires of the input leads to the black, white and
green AC line wires using twist-on wire connectors
and close up the existing junction box.
NOTE: See wiring diagram on last page if connecting
an optional dimming line.
3
Input leads to
junction box
Driver
enclosure