Quick Step Instructions - AquaScape 96030 Instructions & Maintenance

Electrical Specifications
Transformer
• Input Voltage: 120V ac
• Input frequency: 60 Hz
• 6 Watts
• For outdoor or indoor use
• Thermally protected

Quick Step Instructions

1. Carefully remove the dosing
system from the packaging
2. Attach the transformer to
the dosing system power
cord using the quick
connect fitting attached
to the dosing pump main
power cord. (Please note
that the transformer should
be plugged into a GFCI
rated receptacle), the
transformer included is 12V
DC and therefore can be
powered by an existing 12V
transformer used for 12V
lighting.
3. Open the dosing system
container by pressing
the four blue tabs
simultaneously on the
top portion of the dosing
system gently lifting at the
same time.
4. Attach the water treatment
by removing the existing
cap included with the water
treatment, inserting the
proprietary pump tube from
the dosing pump
into the water treatment
and then sealing the
bag with the included
threaded adapter.
5. Place the attached
treatment inside the dosing
system canister.
4
Automatic Dosing System
• Input Voltage: 12V dc
• Input frequency: 60 Hz
• For outdoor or indoor use
2
3
4
5
☎ US 1-866-877-6637 |
• Thermally protected
• This system has been
evaluated for use with the
Automatic Dosing System
Water Treatments only.
6. Attach the included Discharge Tubing to the blue fitting
on the left side of the dosing system control panel, simply
pushing the hose into place until it stops. Ensure that the
check valve is in the right orientation with arrow pointing
away from the dosing system. The Discharge tubing
can be installed two ways, either directly into the pond
or fountain or by using included output hose holder. The
hose holder can be easily attached to plumbing or other
round surfaces.
6
7. To purge the system and get it ready for proper operation
press and hold the X2 button-down until the water
treatment starts dripping out into the pond or fountain. This
may take several minutes depending on the distance from
the dosing pump to the pond or fountain. Make sure to
install the dosing system as close to the water feature
as possible.
7
☎ CAN 1-866-766-3426 | www.aquascapeinc.com