Advertisement
4.2
SINGLE bAY RACKING
See Fig.4. Support two upright angle posts (A) in a vertical
position. Join them together at the base using a short step
beam (C). Tap the beam at either end, close to each angle
post to ensure that the tabs are seated in the slots.
Fig.4
4.3
See Fig.5. Continue to assemble the complete bottom frame
in the order indicated below in Fig.5 starting with a long step
beam (B). Ensure that each step beam is facing upwards. Tap
the beam at either end, close to each angle post to ensure
that the tabs are seated at the bottom of the slots.
4.4
See Fig.6. now make up an upper end frame by connecting
two angle posts together at the top with a short step beam
(C). Tap the beam at either end to ensure that the tabs are
properly seated in the slots. Make up a second upper end
frame using the remaining two angle posts and a short step
beam.
Fig.6
4.5
See Fig.7. Take the 4 post inserts (E) and push them into
the top of the four angle posts of the bottom frame assembly.
now join the two upper end frames to the bottom frame by
mounting each frame onto the post inserts as shown below.
Fig.7
4.6
See Fig.8. now stabilise the frame assembly by inserting a
shelf support halfway up the frame that joins together the
upper and lower parts of the frame. As each step beam is
added ensure that the top tabs are inserted into the bottom
slots of the upper frame and the lower tabs are inserted
into the top slots of the bottom frame as shown below.
Tap the beams at either end to ensure that the tabs are
properly seated into the slots.
Fig.5
Fig.8
AP6500 Issue: 1 - 05/06/09
Advertisement
