Mattel Tyco R/C Turbo Street Wheelie Cycle Manual

Keep these instructions for future reference as they contain important information.
IMPORTANT: Please read all "Consumer Information" before operating your vehicle.
GET STARTED!
Your Turbo Street Wheelie Cycle
motorcycle that allows you to pull off outrageous "one touch"
wheelies. Plus, your Turbo Street Wheelie Cycle
specialized stabilizer that allows for maximum stability for your
most radical stunts.
1.GET SET!
Hold the Turbo Street Wheelie Cycle
throttle button on transmitter.
Be sure to keep your fingers clear of the wheels at all times.
2.LAUNCH IT!
Gently hand-launch your vehicle.
I. CONTENTS/ FEATURES
• Turbo Street Wheelie Cycle
™
• Transmitter
BIKE
Rider Figure (not removable)
1
ON/OFF Switch
2
Battery Latch
3
Battery Compartment
4
TRANSMITTER
NOTE: Your transmitter is equipped with a special automatic
ON battery-saving feature. Just turn your vehicle ON. push
either transmitter button and you will be able to run and
control your bike.
Wheelie Stunt
1
2 Forward
Turn Left
3
4 Turn Right
Battery Compartment
5
Antenna
6
II. QUICK START
Please read this Owner's Manual thoroughly.
1. Start with a Fresh set of batteries.
2. Turn the bike switch ON. Press the transmitter controls to run
and control your bike.
3. When you're done driving, turn the bike switch OFF. Remove
all the batteries for storage.
TM
is a high performance
™
has a
™
off the ground and hold
™
CAUTION:
and cause burns if electronics get wet. Do not
operate vehicle through water or snow.
1
2
FRONT
4
2
1
3
6+
ASST. R5381
R6462/R6463-0920
Surfaces may become hot
4
3
BACK
6
5
®