CM210002 MUK Rev3.qxp_Layout 1 23/03/2017 15:54 Page 6
Preparing Hot Chocolate
and Milkshakes
•
To prepare hot chocolate and cold flavoured milk
drinks, follow steps 1-4 in 'Using Your Milk
Frother' Section on page 4. Ensure the Frothing
(14)
Whisk
is removed and stored as above.
•
Pour in the milk and add the hot chocolate
powder/milkshake syrup.
(1)
•
Replace the Lid
Power/Function Button
double press the Power/Function Button.
•
The Frother will switch off automatically when
done. For hot chocolate, allow 30 seconds to
cool before drinking and always clean your milk
frother before using again.
Pouring the Milk
•
To make the perfect frothy drink, we recommend
you separate the froth from the heated milk. To do
this, use a spoon or spatula to retain the froth in
(5)
the Jug
whilst pouring out the milk slowly. Add
the froth on top afterwards.
6
. For hot chocolate, press the
(6)
once. For milkshakes,
Cleaning
•
In order to keep your worktops clean and tidy,
Stirring Arm
(13)
and Frothing Whisk
sit on the underside of the Lid
milk into the Jug
(5)
.
•
To do this, place the Lid
(3)
that the Lid Magnet
is facing upwards.
Stirring Arm
(13)
•
Stand the
Whisk
(14)
attached)
on the Lid Magnet
•
We recommend that you clean your Frother
immediately after every use by rinsing with warm
soapy water.
•
Remove the Stirring Arm
wash in warm soapy water.
•
Wipe down the outside and inside of the Jug
with warm soapy water and a soft cloth. Do not
use abrasive cleaning solutions or scouring pads
as this removes the non-stick coating.
•
NO PARTS OF THE FROTHER ARE
DISHWASHER SAFE.
•
DO NOT SUBMERGE THE FROTHER IN WATER.
•
WARNING: Take care when cleaning not to get the
electrical components wet.
the
(14)
can
(1)
, when pouring
(1)
on your worktop so
(with the Frothing
(3)
.
(13)
(1)
and Lid
and
(5)