Related Manuals for Dolphin Dolphin Blue DB 1200T
Summary of Contents for Dolphin Dolphin Blue DB 1200T
- Page 1 INSTALLATION AND MAINTENANCE GUIDE DB 1200T & DB 1225T Dolphin Blue Electronic Semi Recessed Piezo Touch Thermostatic Shower Controls DOLPHIN...
- Page 2 INDEX Technical Data Pack Contents Pre-Installation Info Installation 9-12 Flow Time Adjustment 13-14 Maintenance 15-17 Battery Replacement Spare Parts List Trouble Shooting Warranty Dolphin Blue DB 1200T...
-
Page 3: Technical Data
9V DC (DB 1200T) or IP68 Transformer (DB 1225T) Default flow time: 120 seconds. Adjustable Programmable flow time: 5 to 2600 seconds 24 hs.hygiene / anti freeze flush: Optional. Can be enabled or disabled on site. DB 1200T Dolphin Blue... -
Page 4: Pack Contents
1 x Set Screw M5 x 8 1 x Set Screw M5 x 40 1 x Allen key 2.5mm 1 x Set screw M5 x 8 DB 1200T DB 1225T 1 x Screw cover 9v battery box IP68 Transformer Dolphin Blue DB 1200T... - Page 5 All plumbing is to be installed in accordance with applicable codes and regulations. Operation To operate the Dolphin Blue DB 1200T / DB 1225T controls, simply touch the designated area at the Piezo shower control. Default flow time is 2 minutes. If you do not need more water, just touch the designated area again to stop the shower water flow before the default time has passed.
- Page 6 For your convenience the box include two options to connect ½” or ¾” to the water supply pipes. 5. Connect the DB 1200T / DB 1225T box to the pipe leading to the shower head (not supplied). Dolphin Blue DB 1200T...
- Page 7 8. Once the works are finished, cut the protective cover box. 9. Unscrew lightly the screw M5 x 40 located underneath the rosette. DB 1200T Dolphin Blue...
- Page 8 13. Secure the screw M5x40. 14. Now place the Thermostatic Mixing Handle and tighten it with the screw M5x8. 15. Finally place the screw cover into the Thermostatic Mixing Handle hole. Dolphin Blue DB 1200T...
- Page 9 The flow time is programmable on site. If necessary, the default flow time of 30 seconds can be adjusted to any value between 5 to 2600 seconds. The Dolphin Blue Shower Control adjustment mechanism is composed by 3 adjustment levels for changing the flow time.
- Page 10 Do not perform any step at levels 1 and 2 and wait until you reach level 3 (you will get 0 seconds). Total: 0 seconds At level 3 and perform 3 steps of 20 seconds (you will get 60 seconds). Total: 60 seconds. Dolphin Blue DB 1200T...
- Page 11 11.If you do not need more levels, stop pressing. The indicator light will blink 3 times, 4 times and after 5 times you will leave the adjusting mode. The Dolphin Blue Shower Control is now adjusted to the desired flow time.
- Page 12 13. To leave the adjusting mode wait until the LED blinks 4 times and then 5 times. The Dolphin Blue Shower Control is now adjusted to the desired flow time. 14. Reassemble the rosette and the thermostatic mixing handle to the place 15.
- Page 13 Now the check valves do not operate. BE SURE TO REPEAT THIS STEP IN BOTH SIDES 5. When the maintenance works are done, gently open the screws back. DB 1200T Dolphin Blue...
- Page 14 Use of any prohibited cleaning or maintenance products or substances could damage the surface of the shower control. For surface cleaning of shower control us ONLY soap and water, then wipe dry with clean cloth or towel. When cleaning bathroom Dolphin Blue DB 1200T...
- Page 15 Allen key provided. 4. Unscrew the M5x40 screw and now disassemble the thermostatic mixing handle and the rosette. 5. Disconnect from the battery connector and take out the battery cover protection and remove the old battery. DB 1200T Dolphin Blue...
- Page 16 • The interior of the shower control must be fully dry before reassembling the parts. If it not fully dry, carefully dry it. Important: Spent batteries should not be disposed of with normal household waste. Contact your local authority for information on waste disposal and recycling. Dolphin Blue DB 1200T...
-
Page 17: Spare Parts List
DB 07500065 DB 07500065 Thermostatic Mixing Handle DB 07110014 DB 07110014 Piezo button DB 07225176 DB 07225176 Filter DB 08530014 DB 08530014 Check valve DB 08520011 DB 08520011 9 V Battery cover DB 06000136 DB 06522053 DB 1200T Dolphin Blue... - Page 18 Check the flow time. Water flow does not stop Check the solenoid valve. If needed replace the solenoid valve. Check the filter\s. If needed, remove Water flow diminished it\them clean it\them and reinstall it. Dolphin Blue DB 1200T...
-
Page 19: Warranty
If a defect is found in normal use, Dolphin Dispensers will, at its discretion, repair, provide a replacement part or product, or make appropriate adjustments. Damage caused by accident, misuse, or abuse is not covered by this warranty. - Page 20 DOLPHIN Request your 320 page catalogue today on 0800 0723 404 Bell-Chem Products Company Haywood Way, Hastings TN35 4PL Tel: +44 (0)1424 202224 Fax: +44 (0)1424 205 200 info@dolphindispensers.co.uk www.dolphindispensers.co.uk...
Need help?
Do you have a question about the Dolphin Blue DB 1200T and is the answer not in the manual?
Questions and answers