The Extended Menu "Advanced Menu - Sennheiser EK 300 IEM G3 Instruction Manual

Adjusting settings via the operating menu
Switching between "Stereo" and "Focus" mode – "Mode"
SET
Mode
Menu
Mode
Stereo
Stereo
Call up "Mode" Select the desired
setting
"Stored"
The selected audio mode influences the mode of operation of the balance
setting (see previous section).
Audio mode
Stereo
The left-right signals are available
as usual.
The balance setting serves to
adjust the balance between the
left and right stereo signal.
In both audio modes, the corresponding transmitter has to be set to
stereo mode!
Activating/deactivating the treble boost – "High Boost"
Via the "High Boost" menu item, you can boost the treble response of the
output signal (8 dB at 10 kHz).
Output signal remains unchanged High Boost activated
EQ
Activating/deactivating the automatic lock mode – "Auto Lock"
SET
Menu Auto Lock
Auto Lock
Active
A c t i v e
Call up Select the desired
"Auto Lock" setting
"Stored"
The lock mode prevents that the balance is accidentally adjusted when the
receiver is in Focus mode. The lock mode icon
dard display indicates that the lock mode is activated. For information on
how to use the lock mode, refer to page 10.
16
Mode
Focus
Store the setting
SET
Focus
The left-right signals are mixed and
are available as a mono signal in
both headphone channels.
The balance setting serves to
adjust the relative levels of the
two separate channels in the
mixed mono signal.
EQ
Auto Lock
I n a c t i v e
Store the setting
SET
on the current stan-
Adjusting settings via the operating menu
The extended menu "Advanced
To get into the extended menu "Advanced
From the main menu, select "Advanced".
Setting the receiving frequencies and the frequency banks "U1"
to "U6 – "Tune"
When you have selected one of the system banks and then select
the "Tune" menu, the diversity receiver automatically switches to
channel 1 of the frequency bank "U1". In this case, "U1.1" briefly
appears on the display panel.
Upon delivery, the channels of the frequency banks "U1" to "U6"
are not assigned a receiving frequency.
Via the "Tune" menu item, you can:
1. set a receiving frequency to be stored in the current channel of the
selected frequency bank ("U1" to "U6")
2. first select a frequency bank ("U1" to "U6") and a channel and then
assign this channel a receiving frequency.
Setting a receiving frequency for the current channel
Press the UP/DOWN button
appears.
Press the SET button.
SET
The MHz section of the receiving frequency of the channel is
highlighted.
SET
Advanced Menu Tu n e
Tune
823.925 MHz
823.925 MHz
Call up "Tune" Select the frequency
(special function) bank and confirm
"Stored"
It is vital to observe the notes on frequency selection on page 21.
Press the UP/DOWN button
frequency.
Press the SET button to confirm the MHz section of the
SET
frequency.
The kHz section of the frequency is highlighted.
Press the UP/DOWN button
frequency.
Press the SET button to confirm the frequency.
SET
"Stored" appears on the display panel. The "Tune" menu item
appears again.
Menu"
Menu":
or
/ until the "Tune" menu item
SET
Tu n e
823.925 MHz
B.Ch: U1. 1 B.Ch: U1. 1
Select the channel;
store the setting
SET
/ to set the MHz section of the
/ to set the kHz section of the
17