All Flue Options, Final Assembly - Bosch Worcester Greenstar Oilfit External Installation Instructions Manual

INSTALLATION
▶ Push the air inlet inner section through the side panel opening into the
air box until it meets the stops [4] on the clamp assembly
▶ Centralise the inner elbow pipe within the elbow.
▶ Fit the elbow onto the flue cowl.
▶ Tighten the clamp [1] onto the flue elbow.
1
4
5
Fig. 14
[1] Clamp, flue elbow
[2] Air inlet inner section
[3] Air inlet outer section
[4] Clamp stops
[5] Clamp bracket
▶ Drill through the air inlet outer section [3], with the 3.3mm drill bit,
into the inner section [2] and secure the two sections with the self
tapping screw.
Fig. 15
▶ Drill through the clamp tab [6] on the mounting bracket, with the
3.3mm drill bit, into the air inlet outer section and secure with a self-
tapping screw.
3.3mmØ
Fig. 16 Tab detail
8
2&3
6720807912-14.1Wo
3.3mmØ
6
4.5

ALL FLUE OPTIONS, FINAL ASSEMBLY

▶ Lightly grease the flue pipe seal with the solvent free grease supplied.
▶ Remove the screw from the clamp bracket [1] and open the clamp.
▶ Insert the terminal [3] fully into the 80mmØ flue pipe.
▶ Pass the flue pipe [2] through the clamp bracket [1] and push into the
flue cowl or elbow.
Fig. 17 Final assembly
[1] Clamp bracket
[2] Flue pipe
[3] Terminal
▶ Drill two holes into the terminal [3] through the tabs [5], with the
3.3mm drill bit, one either side, and secure the terminal [3] to the
tabs [5] using the two self tapping screws.
▶ Fit the air box cover [4] over the lip on the top of the air box and
secure the bottom two screws removed earlier.
Fig. 18
[4] Air box cover
[5] Tab
1
2
3
6720807912-17.1Wo
4
1
3
5
6 720 807 912 (2015/10)