Opening And Closing Your Tentbox - TentBox CLASSIC Safety And Fitting Instructions

STEP 4: Starting with one of the fixing points you have just created, push
another one of the fixing plates onto the hanging bolts - use the inner two
holes of the fixing plate if possible, or if your cross bars are too thick you
must use the outer two holes.
Now secure the fixing plate to the cross bar using the spanner and nuts
provided. Ensure that the flat side of the nut is facing towards the fixing
plate. Make sure you tighten the nuts on evenly on each side so that the
fixing plate is flat against the cross bar.
The nuts should be tightened evenly on each side until the fixing plate
starts to bend ever so slightly. At this point you must stop tightening.
Make sure that all 4 fixing plates have been correctly installed and that
your TentBox is secure on top of your cross bars.

Opening and closing your TentBox

OPENING: To open your TentBox simply unbuckle the straps on each of
the four corners.
Then, starting from the either the front or back of your TentBox, push the
upper shell gently upwards until it self-erects. Do the same on the opposite
side.
You are now set-up and ready to go!