Tamila D1 User Manual page 7

8. After cleaning is done, turn o the power, and remove the water tank from the
device.
Note: In order to avoid water mist permeating into the bottom of the device, the water tank
and the device body are designed to be xed together tightly. Therefore, when
removing the water tank, it is kind of tight.
Pull up
9. Pour out the remained medicinal alcohol from the water tank, wipe the water
tank and the bottom of the device with tissue paper.
Note:
(1) Please do not soak the water tank in water directly, due to there are motor and
connector at the bottom of water tank.
(2) The water tank and the device body are designed to be seperated, after the mist is
being spraying for a long period of time, some of the mist may accumulate into water
drop inside of the device, this will not a ect the internal circuit. Please use tissue paper
to wipe the interal part of the device.
Clean with cotton bud and alcohol
10. Please dip the tissue paper with alcohol to clean the surface of the oat
switch (water level detector).
Note: When using the essential oil for a long period of time, some essential oil will stain the
surface of the oat switch, it may cause some dirt and stickiness, as well as the
abnormity of oat switch for not being able to oat after water is added up to the
maximum.
11
11. Please dip the tissue paper with alcohol to clean the surface of the small
water tank.
Note: Some essential oils may content additivies, and the additivies may have di erent
12. Please dip the cotton bud with alcohol and wipe
Pull out
along the edge of mesh module gently.
13. After cleaning is done, please plug in the water tank into the device body.
14. Engage the water tank cover with the latch, and press it tightly, then all cleaning
steps are completed.
Note: The device is not waterproof, do not rinse it with water directly when cleaning.
colors; therefore, after using those essential oils with the device for a long period of
time, the small tank will be dyed with colors. It will not a ect the quality of the
small water tank.
Plug in
Engage the cover at
a 45° angle
Push down
Press it tightly
12