Table of Contents
Advertisement
4.2 INSTALLATION
WARNING
When moving the jointer, lift the unit from under the cabinet base. Refrain from using the infeed and outfeed
tables, as they are factory set and should not be disturbed. DO NOT carry or move the machine using the fence
assembly, safety guard, dust chute or hand wheels.
- The machine should be firmly bolted to the floor or mobile base (not included) to avoid any movement of the machine
during use. The jointer's base has holes in each of the four corners for this purpose (hardware is not included).
- Position the machine on a solid, level surface that is located in an area that ample space in front and in back of the
jointer for the moving of lumber to be milled. Align the machine so that during use, any kickback will not face aisles,
doorways, or other work areas that bystanders may be in. Do not locate or use the machine in damp or wet conditions.
WARNING
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH MUST BE IN THE 'OFF' POSITION UNTIL
ASSEMBLY IS COMPLETE
4.3 INSTALLATION TIP
The use of mobile bases to increase portability are common for stationary jointers. Consider starting your assembly with
the mobile base of your choice; building the jointer within the base. This will make it easier to install now rather than
lifting a fully assembled jointer later.
TOOLS REQUIRED FOR ASSEMBLY
Phillips Head Screwdriver, 4mm Allen Wrench, 13mm or an Adjustable Wrench
5. FITTING AND OPERATING OF MACHINE
5.1. JOINTER TOP ASSEMBLY
- Remove rear door of the jointer stand.
- Place jointer top assembly on top of stand, making sure
the pulleys face the rear of the cabinet.Ask a friend for
assistance with this step.
- Line up the four holes in stand top with holesin the bed
assembly. Fig. 5.1.1.
- Install the jointer top to the stand by using four M8 x
40mm Allen bolts, four lock washers and four flat washers.
Fig. 5.1.2.
2
1
-9-
4
FIG.5.1.1
FIG.5.1.2
3
Advertisement
Table of Contents
