Wavelength Automatic Identification; Frequency Detection - Joinwit JW3116 Manual

5.5 Wavelength Automatic Identification

⚫
Connect JW3116 light source with its same serials power meter JW3216.
Enable light source be Under "Wave ID" operation mode: press
⚫
laser on JW2116, Hold down
also "--AU" will be shown on the upper right of LCD for a indication.
⚫ Enable power meter be under "Wave ID"operation mode: Hold down
meter will be enter into Wave ID mode, also "--AU"will be shown on the upper right of LCD for a
indication.
⚫
Once the ID information is changed from light source(press
5 seconds later, the detected information on optical power meter also will be changed automatically
according to light source. Please refer to below figure(5-14) for easy understanding.
⚫
Exit Wave ID mode: Hold down
down again to exit Wave ID mode from light source.
1310nm(xxdBm)
1550nm(xxdBm)
......
JW3116 Light source

5.6 Frequency detection

⚫
Connect JW3116 light source with its same serials power meter JW3216.
⚫
Output frequency from JW3116 optical light source: Press
from the unit, press
of 270Hz、 330Hz、 1KHz、 2KHz accordingly， which will be shown on the upper right of the LCD
in JW3116 light source. In the mean time, the JW3216 power meter will detect the
corresponding frequency automatically from JW3116 light source. Please refer to below figure
(5-15) for better understanding:
Handheld Optical Light Source-JW3116
for few seconds，light source will be enter into Wave ID mode,
again to exit Wave ID mode from power meter and hold
5-14
for very short second，JW3116 light source will output frequencies
12
or
for few seconds，power
to change wavelength), after 3 to
JW3216 Power Meter
or
of light source to
1310nm(xxdBm)
1550nm(xxdBm)
......
to emerge light