Datalogic OM-GRYPHON Series Quick Reference page 18

UK/US
COPY CONFIGURATION
This procedure allows using a previously configured Gryphon™ M reader
(Master) to send its configuration directly to other devices of the same type
(Slaves) by means of a single OM-GRYPHON.
Proceed as follows:
1. With the master Gryphon™ M (correctly configured reader), read the
Copy Configuration barcode below. Then, place it onto the
OM-GRYPHON cradle within 10 seconds. The reader will beep
indicating the configuration has been copied.
With the slave Gryphon™ M, read the Get Configuration barcode
2.
below. Then place it onto the same OM-GRYPHON cradle used in
the step above. The slave reader's address will not be changed.
The configuration will be copied from the master to the slave
Gryphon™ M. The slave Gryphon™ M signals the end of the
procedure with a series of beeps.
Repeat the procedure above to configure other slave readers. The
3.
OM-GRYPHON can continue to configure slave readers until it
receives another command.
This procedure does not require connection to a PC, however
by
OM-GRYPHON the copied configuration will be sent to the
PC.
NOTE
12
Copy Configuration
Get Configuration
connecting the RS232 interface
DATALOGIC
cable to the