Philips 22PFL3405/12 User Manual page 33

This section describes commonly encountered
issues and accompanying solutions.
Disconnect the power cable from the
power outlet. Wait for one minute then
reconnect it.
Check that the power cable is securely
connected.
Check that the remote control batteries
are correctly inserted according to the
+/- orientation.
Replace the remote control batteries if
they are flat or weak.
Clean the remote control and TV sensor
lens.
Disconnect the power cable from the
power outlet. Wait until the TV cools
down before reconnecting the power
cable. If the blinking reoccurs, contact
Philips Consumer Care.
Enter '8888'.
Change the TV menu to your preferred
language.
No action is required. The creaking sound
is normal expansion and contraction of
the TV as it cools down and warms up.
This does not impact performance.
Check that the correct channel list is
selected.
During installation, make sure that
you select the country where you are
installing the TV (see 'Step 2 Select your
country' on page 21).
Check that the antenna is properly
connected to the TV.
Check that the correct device is selected
as the TV source.
Check that the picture settings are
correctly set.
Check that the antenna is properly
connected to the TV.
Loudspeakers, unearthed audio devices,
neon lights, high buildings and other large
objects can influence reception quality.
If possible, try to improve the reception
quality by changing the antenna direction
or moving devices away from the TV.
If reception on only one channel is poor,
fine tune this channel.
Check that the devices are connected
properly.
Check that the picture settings are
correctly set.
• Check that the TV location is set to the
home setting. This mode offers you the
flexibility to change and save settings.
31