Delfi SV-A Instruction Handbook Manual page 9

Delfi
6.1.2. Control Panel
1
1 – Ma ster Switch
4 - Seal (semi-automatic welding)
6.1.3. Vacuum Function
the bags. The vacuum parameter is expressed in second and the formulations of the time
must be adapted to the effective operating requirements in how much the necessary time
for the VACUUM one vary based on the dimensions of the product to Manifacturer.
6.1.4. Welding Function
welding of the bags by means of the appropriate knitting bar tiny of resistance electrical
worker. The welding time differs on the characteristic of the bags, on the temperature and
to the amount of vacuum that is wanted to be carried out. In any case, the welding must
be uniform. For bags of 09/100 gr. is needed to program "timer" to 2 second , for bags
from 100/150gr. to 4 second.
6.1.5. Automatic Function
1) Put the plug in the socket of
2) Press the general sw
3) Regulate the time of vacuum to abo
4) Regulate the time of weldi
5) Put the good in the bag.
6) Put the bag, turned to "elle", under the stainless steel bar.
7) Lower the cover pressurin
8) It makes the welding operation.
9) The opening of the cover is automatic after the working cycle.
6.1.6. Semi-automatic function
1) Insert the plug in the socket of 220V.
2) Press the general switch.
3) Regulate the time of vacuum to about 1
4) Regulate the time of weldin
5) Put the good in the bag.
6) Put th e bag, turned to "elle", under the stainless steel bar.
2 3 4
2 – Vacuum Temporizer
5 – Vacuum Device
-
The Vacuum function allows to activate the extraction of the
-
After the execution of the vacuum, the device proceeds to the
220V.
itch.
ng to abou
g on it until it is closed, with the air aspiration.
g to abou
9
5
3 – Welding Temporizer
ut 15/25 seconds turning the vacuum potentiometer.
t ¾ seconds turning the welding temporizer.
5/25 seconds turning the vacuum potentiometer.
t ¾ seconds turning the welding temporizer.
Manuale d'istruzioni SV-A
Instruction handbook SV-A
air from