Maintenance; Problems And Solutions - Delfi SV-A Instruction Handbook Manual

Delfi
7) Lower the cover pressuring on it until it is closed, with the air aspiration.
8) When the bag is perfectly adherent to the good, press the push-button "SEAL", it makes
the welding operation.
9) The opening of the cover is automatic after the working cycle.
7. TEFLON REPLACEMENT ON THE WELDING BAR
After a long period of use of this machine, is needed to change the welding
Disconnect the power feeling and make sure that the bar is cold.
Disconnect the cables of the bar pressing the superior part of the "fastom".
Remove the bar from the guide.
Remove the cover in Teflon, clean the bar with alcohol and then apply the new Teflon
cutting the exceeding part to the two extremities. Put the bar in the guide and th
the cables.
8.

MAINTENANCE

1) Before any cleaning, maintenance and repair operation, is needed to disconnect the outlet
from the general electrical system.
2) The maintenance
operation, is needed to address to a Technical Center Authorized from the WAAGE s.r.l. It'
is needed to use only original spare parts. A good vacuum and welding quality of the bags
depends on the cleaning of your SV-A. We recommend to control the conditions of the welding
bar. Do not use in any circumstances tools or knives in order to clean up the welding bar.
9.

PROBLEMS AND SOLUTIONS

Afte r the activation of the general switch of the machine and it doesn't start:
1. Verify if the switch and the internal contact of the switch.
2. Verify that lowering the platen, the
pressurised.
3. Control the fuses that are at the inside of the electrical car
The machine gets the vacuum in the bag but it does not make the welding:
Verify if at the moment of the insertion of the welding through the push-button, there are
flashings to side on the clips. If will be this verification, the cause
electrical worker.
The platen does not remain closed, also exercising the corrected pressure:
Verify that the gasket put under the platen with handle will be perfectly integrated and will tie
in the inferior plate
operations must be carried out from qualified people. For any repairs
micro switch placed at the inside of the machine will be
n and that the bag comes place without any anomalies.
10
d.
Manuale d'istruzioni SV-A
Instruction handbook SV-A
bar in the following way:
en connect
would be the resistance of