Reception Test - Ariston Chaffoteaux 3318591 Assembly And Operation Instructions Manual

GB

RECEPTION TEST

To check the correct communication be-
tween the receiver and transmitter, power
the timer-thermostat using the batteries
provided with the kit, as described in the
relative instruction manual.
Keep the timer-thermostat at least 2-3
metres away from the receiver and per-
form the following procedure:
- Press button
- Press buttons "
with the PROGRAM "
roughly 3 seconds. The display will vis-
ualise "TRANSMISSION TEST' and will
send the test signal to the receiver.
- The green LED on the receiver will start
fl ashing every 5 seconds for maximum
10 minutes. (During these 10 minutes
the receiver will not send any signal to
the boiler).
- Find a suitable zone in which to posi-
tion the timer-thermostat, while veri-
fying that the signal transmission is
not interrupted (green LED fl ashing).
- Press the
mode.
NOTE:
If the red LED fl ashes on the receiver, the
transmission signal is inadequate.
Perform the receiver-transmitter recogni-
tion procedure.
LED
GREEN fl ashing
GREEN on
GREEN off
RED fl ashing
RED on
RED off
12
.
" together
" button for
button to exit the TEST
CAUSE
recognition of receiver-transmitter transmission
reception of transmitter signal
receiver ready for normal operation
receiver in re-connection mode
communication between receiver and transmitter interrupted
receiver ready for normal operation
GREEN LED
RED LED
BUTTON